Duraflex International

Information

Dealer Production Questionnaire

Please complete and return this sheet to us so we can place your order on the production schedule.

What is the name of the Pool or Job Site, and in which State is it located?

Is this an Indoor or an Outdoor Pool? (Please Select one)

What Stand are you ordering, or ordering Parts for?

	Quantity	Specify Model of Board going on Stand
Short Stand
One Meter
Three Meter
(Board Models are 16’ Maxi-B, 16’ Maxiflex, 16’ Duraflex, 14’ Duraflex)

Addition or Replacement Stands

If these Stands are an addition or replacement to an existing Durafirm installation at the pool, the following information is required: Full casting # found inside (near the top) one of the main support sides (not ladder assembly). This number will read 3M or 1M401-? # (? # is the number we need).
Casting#:

Vertical Distance to Water Line

What is the vertical distance between the level of the water and the level of the deck where the Stand will be installed?
(DECK TO WATER LEVEL)

Rate of Slope of Stand Deck

What is the rate of slope of the deck where the Stand will be located?	(inches/foot)
Does the deck slope TOWARD or AWAY from the pool edge?

Stand Deck Anchoring


a) Will these Stands use Hilti epoxy inserts (for Existing Decks)?
(8 Inserts for each 1M or 3M Stand.) Not recommended for Short Stands.

OR

b) Will these Stands use bronze deck anchors?
If either a) or b) is “yes,” have you included them on your purchase order?
If “yes” to bronze anchors, do you want us to ship them ahead of the Stands?
(Shipping anchors ahead is primarily for the purpose of setting them in a new concrete pour andhaving them in place for the arrival of the Stands.) Anchors shipped ahead will go to the ship-to address on the purchase order unless a specific alternative address is provided. A layout will be provided at this time.